List of Receiver options compatible with STI Field Test 6 the STI-9400 and the STI-9450

General Purpose Instruments

Frequency Ranges from 1 MHz to 1 GHz. The most common solution this scanning receiver is Calibrated and integrated into the mounting hardware of the STI-9400 and STI-9450 configurations.

Frequency Range from 2 MHz to 1 GHz operation. The 3500 Interface will automate a series of measurements and record signal power levels during a drive-test.

Frequency Range from 1 MHz to 2.7 GHz. The 2975 Interface will automate a series of measurements and record signal power levels, Audio SINAD from an analog mobile radio, or BER from a compatible P-25 mobile during a drive-test.

Frequency Range from 250kHz to 1GHz. Interface will automate a series of measurements and record signal power levels at one or more frequencies during a drive-test.

Interface drivers offered for the Agilent ESA 44xx series and HP 85xx series for example. Cost depends on hardware requirements (HPIB or RS-232) and the frequency ranges vary by device, see specification of your analyzer and contact STI to see if your Agilent is compatible

Interface to MS2711 is via an RS-232 connection and the analyzer's frequency range is 100 kHz to 3 GHz. The STI Interface to MS2721 is via network connection and the frequency ranges up to 7 GHz.

Interface to General Dynamics 2670 is via RS-232 connection.

This hardware and software option provides a general purpose interface to electronics of all types. The A/D converter accepts up to 4 input voltages from +/- 10 Volts. A table can be created to convert RSSI voltage to calibrated signal strength. The A/D converter is also used for Audio Quality Testing of analog mobile radio voice links.